The Spring Torque Tester

The Secure Pak Spring Torque Tester is designed to control cap tightness – an essential factor – in bottling operations:

• When caps are not applied tightly enough, leakage or evaporation of product may occur.

• When caps are applied too tightly, molded closures may be susceptible to breakage, or the caps may be difficult to remove.

Secure Pak Spring Torque Testers are available in two different models:

 • The MR model has an indicator on the removal side only.

 • The MRA model has indicators on both the removal and application sides.

Both the MR and MRA models are available in the following standard ranges:

 • 0-25 inch lbs., which reads in 1 inch lb. increments

 • 0-50 inch lbs., which reads in 2 inch lb. increments

 • 0-100 inch lbs., which reads in 5 inch lb. increments

 • 0-150 inch lbs., which reads in 10 inch lb. increments

Special order ranges are available:

 • 0-2 inch lbs., which reads in 0.1 inch lb. increments

 • 0-5 inch lbs., which reads in 0.2 inch lb. increments

 • 0-10 inch lbs., which reads in 0.5 inch lb. increments

The Secure Pak Spring Torque Testers have an accuracy of ±4% of full scale or reading.